Smart Energy-Saving Tips: How to lower your electricity bills by using rental HVAC units

The biggest challenge every consumer faces with the air conditioner and furnace rental units is the inflated power bills. One of the best ways to make sure that your energy bills are low and steady is to hire the unit from a reputable HVAC contractor in Toronto. Once installed, there is not much scope to extract highest efficiency from a rented unit, unless some parts like air filters and vents are inspected for damage and repaired immediately.

hvac contractors in toronto

In order to save you the time, effort and cost in the long run, here are 5 smart tips to help you lower your energy bills while using rental HVAC units.

1. Proper ductwork installation

Ductwork installation is the most important step in AC and furnace installation. Test for any visible leaks or cracks in the pipe. If there is a foul smell in the air the moment you start the blower, there could be a leakage in the duct. The air filter could be damaged as well.

If there is a leakage, you can either tape it yourself, or call the HVAC contractor to inspect into the matter.

2. Always clean/replace air filters whenever bills go high

Blocked air filters put increased pressure on the working of the HVAC units. It is recommended that the air filters should be either cleaned or replaced before Air Conditioner installation. If you experience inefficient cooling and dusty air blow, blame it on the air filter.

3. Is the spot shaded?

Is your outdoor furnace air conditioner unit exposed to moisture or sun during its operation? If yes, put up a shade around it and muffle it with an insulation cover to prevent loss of energy from the system. Covering the unit easily saves 10-15% on energy bills.
Exposure to moist areas, especially if you live on the top floor, can cause poor performance of the Air Conditioner rental units.

4. Manage your thermostat settings

Most users get their thermostat settings wrong. It is due to the lack of awareness about the operation cycle. The recommended thermostat setting is to keep it 10-15 degrees lower than the outside temperature for 8 hours per day in the daytime. Depending on the size of the room and the number of occupants, you could consider the temperature control accordingly.

hvac toronto

Always consult with the HVAC contractor before manually operating the settings. If you are not familiar about the thermostat settings and wish to keep the energy bills in control, opt for a fully-automated thermostat controlled Air Conditioner on rental from HVAC contractors in Toronto.

5. Manage your other electrical appliances

Running tankless water heaters and air conditioner together at the same time can inflate your energy bills significantly. Opt for cooler light lamps and try replacing your old TV set with a flat, energy-efficient LED TV. Avoid incandescent lamps when the AC is running. However, you can consider using a ceiling/wall-mounted fan with AC to reduce energy bills.

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s